Tl-audio EQ-2 Manuel d'utilisateur télécharger pdf (Page 13)

EQ2 Parametric Equaliser Technical Specification.

Inputs: Line level balanced @ +4dBu nominal, via XLR sockets, plus unbalanced on jack sockets.

Maximum input +24dBu, input impedance greater than 5Kohm.

Instrument input on front panel jack, switchable to high/low gain for guitar or keyboard.

Maximum input level +22dBu. Input impedance 220Kohm.

Mic input balanced on XLR, with switchable phantom power. EIN -127dBu (150 ohms,

22Hz-22KHz).

Input gain range + 16dB to +60dB (Mic), -22dB to +22dB (Line).

Filters: Continuously variable, individually switched high and low pass filters, 12dB per octave.

LF cut frequency range 30Hz to 1KHz, HF cut frequency range 1KHz to 25KHz.

Equalisation:

Four bands per channel, individually switched, plus overall EQ ON switch.

Each channel fully parametric, with continuously variable cut/boost, frequency and Q.

LM and HM bands peaking, LF and HF bands switchable to shelving or peaking response.

Cut and boost: +/-15dB.

Frequency range, LF and LM: 30Hz to 3KHz.

Frequency range, HM and HF: 1KHz to 20KHz.

Q range 0.5 to 5.

Stereo Operation:

Full stereo ganging of all EQ controls, i.e. cut/boost, frequency, Q controls and in/out buttons.

Overall EQ IN buttons, filters, input gain and output gain remain seperate.

Drive and Peak LEDs:

Variable intensity drive LEDs, start to glow at threshold of valve compression.

Peak LEDs indicate approximately 2dB of headroom remaining.

Monitor point is the EQ output, prior to master level control.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19

Pas de commentaire

Tl-audio EQ-2 Manuel d'utilisateur Page 13