T L Audio User Manual PA1 PENTODE PRE-AMPLIFIER Tony Larking Professional Sales Limited, Letchworth, England. Tel: 01462 4906
SPECIFICATIONS Mic Input: Transformer balanced, input impedance greater than 1K5ohm, to suit 150-600 ohm microphones. 48V phantom
Power Requirements: Rear panel selectable for 220-240V 50Hz or 110-120V 60Hz operation. Rear panel fuse 20mm, 1AT. Power consumptio
INTRODUCTION The T L Audio Dual Pentode Pre-Amplifier is a very high quality, valve based microphone and instrument amplifier. Transformer cou
PRECAUTIONS The T L Audio Pentode Pre-Amplifier requires very little installation, but like all electrical equipment, care must be taken to ensure
Warning: attempted operation on the wrong voltage setting, or with an incorrect fuse, will invalidate the warranty. Audio Inputs
Outputs. The outputs are via balanced, 3 pin male XLR connectors. The mating connectors should be wired as follows: - Pin 1 = Ground (screen),
OPERATION. Front Panel. The front panel controls are shown in fig.3. Input Stage. Ensure that the correct input connector, mic or instrument,
Phase Reverse. Channel A features a phase reverse switch, which may be used to correct a phase error introduced elsewhere in a stereo signal path b
Commentaires sur ces manuels